Bağlantılar & Faydalı Linkler
ZİYARETÇİ SAYIMIZ
Online : 1
Bugün : 3
Dün: 24
Bu Ay : 424
Toplam: 132562
Single component polyurethane-based adhesive for
NECURON®-modeling materials
Pot life: approx. 90 minutes at 20°C |
|||
Curing time: approx. 5 - 6 hours at 20°C approx. 2 - 3 hours at 40°C approx. 1 - 2 hours at 60°C In most cases application to one side is sufficient. |
|||
Technical data:
|
|||
Processing: | |||
The ideal application temperature is around 20°C. Do not process under +5°C. Surfaces must be clean, dry, free of dust and grease. Release agents must be removed from plastic surfaces. Curing: Due to the influence of humidity, the adhesive cures to a water resistant, solvent resistant, semi-rigid adhesive film. Curing is accelerated by increased humidity of temperature. Cure under pressure. This guarantees, that the parts to be glued are not pushed apart due to the expanding adhesive. Application dosage : 100-500 g/m2 according to type of material Consistency: thin fluid |
|||
Subsequent machining: Possible after one day, the adhesive is fully cured within approx. 7 days |
|||
Delivery/packing unit: tin container 5 kg net |
|||
data sheet (pdf format) for downloading | |||
safety data sheet (pdf format) for downloading |